Firmware
Upgrading firmware can be done in one of three ways.
Using the router’s interface to automatically check for an update, using the router’s interface to
manually upgrade the firmware, or using InControl2 to push an upgrade to a router.
The automatic upgrade can be done from
System
>
Firmware
.
If an update is found the buttons will change to allow you to
Download and Update
the
firmware.
Click on the
Download and Upgrade
button. A prompt will be displayed advising to download the
Current Active Configuration. Please click on the underlined download text. After downloading the
current config click the
Ok
button to start the upgrade process.
The router will download and then apply the firmware. The time that this process takes will
depend on your internet connection’s speed.
The firmware will now be applied to the router*. The amount of time it takes for the firmware to
upgrade will also depend on the router that’s being upgraded.
*Upgrading the firmware will cause the router to reboot.
Web admin interface : install updates manually
In some cases, a special build may be provided via a ticket or it may be found in the forum.
Upgrading to the special build can be done using this method, or using IC2 if you are using that to
manage your firmware upgrades. A manual upgrade using the GA firmware posted on the site
To Next Page
Loading...
