may also be recommended or required for a couple of reasons.
All of the Peplink/Pepwave GA firmware can be found here
(https://www.peplink.com/support/downloads/) Navigate to the relevant product line (ie. Balance,
Max, FusionHub, SOHO, etc). Some product lines may have a dropdown that lists all of the
products in that product line. Here is a screenshot from the Balance line.
If the device has more than one firmware version the current hardware revision will be required to
know what firmware to download.
Navigate to System > Firmware and click the Choose File button under the Manual Firmware
Upgrade section. Navigate to the location that the firmware was downloaded to select the “.img”
file and click the Open button.
Click on the Manual Upgrade button to start the upgrade process.
A prompt will be displayed advising to download the Current Active Configuration. Please click on
the underlined download text. After downloading the current config click the Ok button to start
the upgrade process. The firmware will now be applied to the router*. The amount of time it takes
for the firmware to upgrade will depend on the router that’s being upgraded.
*Upgrading the firmware will cause the router to reboot.
The InControl method
Described in this knowledgebase article on our forum. (https://forum.peplink.com/t/upgrading-
firmware-the-incontrol2-method/)
Time
Time Settings
enables the system clock of the Pepwave router to be synchronized with a
specified time server. Time settings are located at
System>Time
.
To Next Page
Loading...
