Event Log Settings
Remote
Syslog
This setting specifies whether or not to log events at the specified remote
syslog server.
Remote
Syslog Host
This setting specifies the IP address or hostname of the remote syslog server
and port that is used.
Source
Network
Address
Via drop-down list, you may choose the LAN interface for Event Log, URL
Logging, Sessions Logging and RADIUS.
Push Events
The Pepwave router can also send push notifications to mobile devices that
have our Mobile Router Utility installed. Check the box to activate this
feature.
For more information on the Router Utility, go to:
www.peplink.com/products/router-utility
(http://www.peplink.com/products/router-utility)
URL Logging
This setting is to enable event logging at the specified log server.
URL Logging
Host
This setting specifies the IP address or hostname of the URL log server.
Session
Logging
This setting is to enable event logging at the specified log server.
Session
Logging
Host
This setting specifies the IP address or hostname of the Session log server.
SNMP
SNMP or simple network management protocol is an open standard that can be used to collect
information about the Pepwave router. SNMP configuration is located at
System>SNMP
.
To Next Page
Loading...
