SNMP Settings
SNMP Device Name
This field shows the router name defined at
System>Admin
Security
.
SNMP Port
This option specifies the port which SNMP will use. The default port
is
161
.
SNMPv1
This option allows you to enable SNMP version 1.
SNMPv2
This option allows you to enable SNMP version 2.
SNMPv3
This option allows you to enable SNMP version 3.
SNMP Trap
This option allows you to enable SNMP Trap. If enabled, the
following entry fields will appear.
SNMP Trap
Community
This setting specifies the SNMP Trap community name.
SNMP Trap Server
Enter the IP address of the SNMP Trap server.
SNMP Trap Port
This option specifies the port which the SNMP Trap server will use.
The default port is
162
.
SNMP Trap Server
Heartbeat
This option allows you to enable and configure the heartbeat
interval for the SNMP Trap server.
To add an SNMP community, click the
Add SNMP Community
button in the
Community Name
table; the following screen will be displayed:
To Next Page
Loading...
