Use IP ToS
A If Use IP ToS is enabled, the ToS value of the data packets will be copied
to the PepVPN header during encapsulation.
Latency
Difference Cutoff
A
Traffic will be stopped for links that exceed the specified millisecond
value with respect to the lowest latency link. (e.g. Lowest latency is
100ms, a value of 500ms means links with latency 600ms or more will
not be used)
Multiple PepVPN
profiles between
the same 2 sites
A
Enable this advanced feature to create up to 5 PepVPN tunnels from
your router to the same remote location, each with different behavior.
See: https://forum.peplink.com/t/outbound-policies-within-a-pepvpn-or-
speedfusion-tunnel/ (https://forum.peplink.com/t/outbound-policies-
within-a-pepvpn-or-speedfusion-tunnel/)
A – Advanced feature, please click the
button on the top right-hand corner to activate.
To enable Layer 2 Bridging between PepVPN profiles, navigate to
Network > LAN > *LAN Profile
Name*
.
WAN Connection Priority
If your device supports it, you can specify the priority of WAN connections to be used for making
VPN connections. WAN connections set to
OFF
will never be used. Only available WAN connections
with the highest priority will be used.
To enable asymmetric connections, connection mapping to remote WANs, cut-off latency, and
packet loss suspension time, click the
button.
To Next Page
Loading...
