Port
Forwarding
Settings
Enable
This setting specifies whether the inbound service takes effect. When
Enable
is
checked, the inbound service takes effect: traffic is matched and actions are
taken by the Pepwave router based on the other parameters of the rule. When
this setting is disabled, the inbound service does not take effect: the Pepwave
router disregards the other parameters of the rule.
Service
Name
This setting identifies the service to the system administrator. Valid values for
this setting consist of only alphanumeric and underscore “_” characters.
Protocol
The
Protocol
setting, along with the
Port
setting, specifies the protocol of the
service as TCP, UDP, ICMP, or IP. Traffic that is received by the Pepwave router via
the specified protocol at the specified port(s) is forwarded to the LAN hosts
specified by the
Servers
setting. Please see below for details on the
Port
and
Servers
settings. Alternatively, the
Protocol Selection Tool
drop-down menu can
be used to automatically fill in the protocol and a single port number of common
Internet services (e.g. HTTP, HTTPS, etc.). After selecting an item from the
Protocol Selection Tool
drop-down menu, the protocol and port number remain
manually modifiable.
To Next Page
Loading...
