Port
The
Port
setting specifies the port(s) that correspond to the service, and can be
configured to behave in one of the following manners:
Any Port
,
Single Port
,
Port Range
,
Port Map
, and
Range Mapping
Any Port
: all traffic that is received by the Pepwave router via the specified
protocol is forwarded to the servers specified by the
Servers
setting. For
example, with
IP Protocol
set to
TCP
, and
Port
set to
Any Port
, all TCP traffic is
forwarded to the configured servers.
Single Port
: traffic that is received by the Pepwave router via the specified
protocol at the specified port is forwarded via the same port to the servers
specified by the
Servers
setting. For example, with
IP Protocol
set to
TCP
, and
Port
set to
Single Port
and
Service Port
80, TCP traffic received on port 80 is
forwarded to the configured servers via port 80.
Port Range
: traffic that is received by the Pepwave router via the specified
protocol at the specified port range is forwarded via the same respective ports to
the LAN hosts specified by the
Servers
setting. For example, with
IP Protocol
set
to
TCP
, and
Port
set to
Port Range
and
Service Ports
80-88, TCP traffic received
on ports 80 through 88 is forwarded to the configured servers via the respective
ports.
Port Mapping
: traffic that is received by Pepwave router via the specified
protocol at the specified port is forwarded via a different port to the servers
specified by the
Servers
setting.For example, with
IP Protocol
set to
TCP
, and
Port
set to
Port Mapping
,
Service Port
80, and
Map to Port
88, TCP traffic on
port 80 is forwarded to the configured servers via port 88.(Please see below for
details on the
Servers
setting.)
Range Mapping
: traffic that is received by the Pepwave router via the specified
protocol at the specified port range is forwarded via a different port to the
servers specified by the
Servers
setting.
To Next Page
Loading...
