Pepwave Surf SOHO - Page 74

Enable This setting specifies whether the firewall rule should take effect. If the box
is checked, the firewall rule takes effect. If the traffic matches the specified
protocol/IP/port, actions will be taken by the Pepwave router based on the
other parameters of the rule. If the box is not checked, the firewall rule does
not take effect. The Pepwave router will disregard the other parameters of
the rule.
Click the dropdown menu next to the checkbox to place this firewall rule on
a time schedule.
WAN
Connection
(Inbound)
Select the WAN connection that this firewall rule should apply to.
Protocol This setting specifies the protocol to be matched. Via a drop-down menu,
the following protocols can be specified:
Any
TCP
UDP
ICMP
DSCP
IP
Alternatively, the Protocol Selection Tool drop-down menu can be used to
automatically fill in the protocol and port number of common Internet
services (e.g., HTTP, HTTPS, etc.)
After selecting an item from the Protocol Selection Tool drop-down menu,
the protocol and port number remains manually modifiable.
Source IP &
Port
This specifies the source IP address(es) and port number(s) to be matched
for the firewall rule. A single address, Network, MAC Address or Grouped
Network can be specified as the Source setting.
Destination
IP & Port
This specifies the destination IP address(es) and port number(s) to be
matched for the firewall rule. A single address, Network, MAC Address or a
Grouped Network, can be specified as the Destination setting.
Action This option allows you to define whether to allow or deny an IP session
matching this Firewall Rule