Event
Logging
This setting specifies whether or not to log matched firewall events. The
logged messages are shown on the page
Status>Event Log
. A sample
message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
●
CONN:
The connection where the log entry refers to
●
SRC:
Source IP address
●
DST:
Destination IP address
●
LEN:
Packet length
●
PROTO:
Protocol
●
SPT:
Source port
●
DPT:
Destination port
Click
Save
to store your changes. To create an additional firewall rule, click the
Add Rule
and
repeat the above steps.
To change a rule’s priority, simply drag and drop the rule:
Hold the left mouse button on the rule.
Move it to the desired position.
Drop it by releasing the mouse button.
To remove a rule, click the button.
Rules are matched from top to bottom. If a connection matches any one of the upper rules, the
matching process will stop. If none of the rules match, the Default rule will be applied. By default,
the
Default
rule is set as
Allow
for Outbound, Inbound and Internal Network access.
To Next Page
Loading...
