Action
With the value of
Allow
for the
Action
setting, the matching traffic passes
through the router (to be routed to the destination). If the value of
the
Action
setting is set to
Deny
, the matching traffic does not pass through
the router (and is discarded).
Event
Logging
This setting specifies whether or not to log matched firewall events. The
logged messages are shown on the page
Status>Event Log
. A sample
message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
CONN:
The connection where the log entry refers to
SRC:
Source IP address
DST:
Destination IP address
LEN:
Packet length
PROTO:
Protocol
SPT:
Source port
DPT:
Destination port
Content Blocking
To Next Page
Loading...
