To Next PageTo Next PageWhy Perfect Aire Air Conditioner cooling but room is too warm?
If your Perfect Aire Air Conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, set the unit to FAN only mode to defrost the coil. This issue may arise if the outdoor temperature is below 64ºF (18ºC), the air filter is dirty (clean it), or the thermostat is set too low for nighttime cooling (adjust the temperature to a higher setting).
How to fix Perfect Aire Air Conditioner not cooling room?
To address a Perfect Aire Air Conditioner that isn't cooling well, ensure it's appropriately sized for the room. Confirm that all doors, windows, and curtains are closed, and that nothing is blocking the unit's front grille. Allow sufficient time for the room to cool, especially in high outside temperatures. Also, check that the filter isn't dirty, the louvers are fully open and directed correctly, and the unit is set to COOL mode with an adequate (but not too low) temperature setting. If the unit is near a heat source, relocate it. If the air is cool to the touch, recheck the points above. Move the remote away from the unit if using the Follow Me feature. Finally, unplug the unit for at least 5 minutes and follow the reset instructions on the plug.
What to do if Perfect Aire PORTQ12000 unit will not turn on?
If your Perfect Aire Air Conditioner won't turn on, and a P1 error code appears, drain the water from the bottom tray. Reset the circuit breaker, ensuring that the breaker isn't overloaded with too many devices. Check the plug connection and verify the on/off switch is in the 'on' position if applicable. Try plugging the unit into a different outlet. Check the temperature setting. As a last resort, unplug the unit for at least 5 minutes and follow the reset instructions on the plug.
What to do if Perfect Aire PORTQ12000 blows fuses?
If your Perfect Aire Air Conditioner is blowing fuses or popping the circuit breaker, ensure there are enough available amps on the circuit for the air conditioner. Large units operating on 230v may require a dedicated 20 or 30 amp circuit.
How to fix Perfect Aire PORTQ12000 making noises?
To address a noisy Perfect Aire Air Conditioner, begin by checking the unit for any debris or obstructions. Inspect the fan blade for cracks or chips. Ensure that the window slider kit is correctly and securely mounted inside the window. Finally, clean the air filter.
Why Perfect Aire PORTQ12000 Air Conditioner cycling on and off too frequently?
To solve the issue of a Perfect Aire Air Conditioner cycling on and off too frequently, ensure the unit is appropriately sized for the room. Make sure nothing is blocking the louvers. Check the unit and filter for any dirt or debris.
What to do if Perfect Aire PORTQ12000 Air Conditioner remote sensing deactivating prematurely?
If the Remote Sensing/Follow Me feature on your Perfect Aire Air Conditioner is deactivating prematurely, ensure the remote control is within a 20 ft range and 180º radius of the unit's front. Remove any obstructions that may be blocking the remote control signal. Try replacing the batteries in the remote control with a fresh set.
General| Cooling Capacity | 12000 BTU |
|---|---|
| Type | Portable |
| Voltage | 115V |
| Power Supply | 115V/60Hz |
| Power Consumption | 1200 W |
| Refrigerant | R410A |
| Noise Level | 54 dB |
| Cooling Area | 450 sq. ft. |
Important safety instructions and warnings for using the air conditioner to prevent injury and damage.
Guidelines for proper grounding, extension cord usage, and electrical service requirements.
Precautions regarding installation location, unit handling, and preventing hazards like tipping or water contact.
Instructions for managing water drainage during dehumidifying and when the unit is full.
How to set and operate the air conditioner in cooling mode.
Steps to diagnose and resolve issues with insufficient cooling.
Solutions for when the unit is cooling but the room remains warm or ice forms.
Steps to resolve power-on issues for the air conditioner.
Causes and solutions for electrical circuit protection issues.
