What to do if my Perfect Aire PAC5000 Air Conditioner will not turn on?
If your Perfect Aire unit won't turn on: * Reset the circuit breaker, ensuring not too many items are on the same breaker. * Check the plug connection. * If the plug is switch-operated, ensure the switch is 'on'. * Try a different outlet. * Unplug the unit for at least 5 minutes and follow the reset instructions on the plug.
What to do if water is puddling inside my Perfect Aire Air Conditioner?
If you notice water puddles inside your Perfect Aire unit or water is coming into the room: * Adjust the unit's slope so it drains outward. Refer to the Installation Instructions for guidance. * Ensure nothing is blocking the unit's drainage area.
Why is my Perfect Aire PAC5000 dripping water outside?
Water dripping outside your Perfect Aire unit is normal on humid days, as the unit removes moisture from the room.
Why does my Perfect Aire Air Conditioner keep turning on and off?
If your Perfect Aire air conditioner is cycling on and off too frequently, or not enough, consider the following: * Ensure the unit isn't too large or small for the room. * Check that the temperature sensor isn't too close to the coils; straighten the tube if necessary. * Make sure nothing is blocking the grille or side vents. * Ensure there's no dirt or debris inside the unit or on the filter.
What to do if my Perfect Aire PAC5000 is cooling but the room is too warm and ice is forming?
If your Perfect Aire air conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, it could be due to a few reasons: * If the outdoor temperature is below 64ºF (18ºC), set the unit to Fan Only mode to defrost the coil. * A dirty air filter can cause this issue. Clean the filter, referring to the Care and Cleaning section. * If the thermostat is set too cold for night-time cooling, defrost the coil by setting it to Fan Only mode, then raise the temperature setting.
How to troubleshoot a noisy Perfect Aire PAC5000 Air Conditioner?
If your Perfect Aire air conditioner is making unusual noises: * Ensure the unit is free from debris like leaves or sticks and that nothing is obstructing it. * Inspect the fan blade for cracks or chips. * Verify the unit is properly and securely mounted in the window or wall. * Clean the air filter.
Why does my Perfect Aire Air Conditioner keep blowing fuses?
If your Perfect Aire unit blows fuses or trips the circuit breaker: * Ensure the circuit has enough available amps for the air conditioner. * Large 230v units need a dedicated 20 or 30 amp circuit.
Why does the Follow Me function on my Perfect Aire Air Conditioner turn off early?
If the Remote Sensing/Follow Me feature on your Perfect Aire air conditioner is deactivating prematurely: * Make sure the remote is within 20 ft and a 180º radius of the unit's front. * Remove any obstructions blocking the remote's signal.
General| Type | Portable Air Conditioner |
|---|---|
| Voltage | 115V |
| Noise Level | 52 dB |
| Refrigerant | R410A |
| Power Source | Corded Electric |
Details on electrical service, grounding, and receptacle requirements.
Instructions for testing the power supply cord's current detection device.
Specifies the window size and type suitable for installation.
Addresses issues where the air conditioner does not cool the room or blow cold air.
Steps to take if the air conditioner unit fails to power on.
Explains why fuses might blow or circuit breakers trip and how to resolve.
To Next Page