Fig. 28
Rotisserie Lighting
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the
rotisserie counter-clockwise to the “HIGH” position.
Continue push the knob and wait 5 seconds.
You’ll hear
a snapping sound. If the burner does not light in 4 seconds,
turn the control knob to "OFF" and wait 5 minutes before
trying again. Once lit, turn the control knob to the desired
setting. (See Fig. 27)
If the igniter does not function, the burner can be lit by
holding a lit match to the burner while the control knob is
turned counter-clockwise to “HIGH”. (See Fig. 28)
NOTE: After the rst use the stainless steel around the
burner will darken. This is a normal reaction of premium
stainless steel due to heat and is not a defect. The
infrared panel will also darken after initial use. This is
also a normal occurrence.
NOTE: Do not operate the main burners and
infrared back burner at the same time. This can
cause warping of the roll top grill hood.
Fig. 27
17
To Next Page
Loading...
