6. Condition:
PerfectPass has no digital speed reading.
Solution:
1. Check Master Module to ensure paddlewheel cable is properly connected and
pins are in proper position and not bent.
2. Does paddle spin freely?
3. If all looks well, perform a “System Reset”.
7. Condition:
UP key on Display does not respond.
Solution:
Make sure all 10 pins on Master Module are in-line where display connects. If
connection is OK, key pad switch is faulty, return to PerfectPass for repair.
8. Condition:
Boat speed drops and throttle handle must be pushed far down to get acceleration.
Solution:
Servo motor is not holding and rotating properly usually due to a bad connection
at the servo motor. See Servo Motor Test, Page 11.
9. Condition:
System is blowing the 5 amp, 1.25” fuse on 12 V power cable.
Solution:
Generally caused by a short or “grounding” problem with the red 12 V power
cable on servo motor. Closely inspect wiring particularly around gold resistor.
(Remember, resistor & servo motor will run very hot which is normal).
10. Condition:
Speed in Slalom mode not accurate.
Solution:
Did you go into Calibrate by highlighting MENU arrow , then press DOWN
Key. This screen allows you to adjust an RPM baseline up or down so speed is
more accurate. If you believe the PerfectPass digital speedometer is not
accurate, see “Digital Speedometer Adjust” on Page 7, which is performed in
Wakeboard Mode.
11. Condition:
Speed reading on PerfectPass very low.
Solution:
- Inspect paddle, does it spin freely?
- Is arrow on paddle housing pointing towards bow? Is impellar in correct
direction?
- If paddle looks O.K., perform a “System Reset” to re-establish calibration
settings. See Page 11.
To Next Page
Loading...