How to fix irregular pattern with Performance Tool H.V.L.P. Spray Gun?
An irregular or offset pattern from your Performance Tool Paint Sprayer can be due to a dirty or damaged Needle tip or Fluid Nozzle, so clean or replace them. It may also be caused by clogged atomization holes on the Air Nozzle around the center, in which case you should clean the Air Nozzle.
What to do if my Performance Tool Paint Sprayer is spitting?
Spitting from the Performance Tool Paint Sprayer can occur if there's too little material in the cup, so refill it. Also, check if the Fluid Nozzle is loose and tighten it. Damaged Needle Packing can also cause this, so replace the packing if needed. Finally, a dirty or damaged Needle and Nozzle Set might be the culprit; try cleaning or replacing these parts.
Why is material in cup bubbling in my Performance Tool H.V.L.P. Spray Gun Paint Sprayer?
Bubbling or 'boiling' material in the cup of your Performance Tool Paint Sprayer can be caused by a Fluid Nozzle that is loose, clogged, or damaged; in this case, clean, tighten, or replace it. Another potential cause is an Air Nozzle that is loose, clogged, or damaged; thus, you should clean, tighten, or replace it as well.
Why Performance Tool Paint Sprayer produces half-moon shaped pattern?
A half-moon shaped pattern from your Performance Tool Paint Sprayer is often caused by clogged air holes on the Air Nozzle ears. Carefully clean out these holes with wire after soaking them in thinner.
Wear approved eye, ear, and breathing protection during operation.
Avoid spraying near sparks, open flames, or ignition sources; do not smoke.
Avoid specific solvents like 1,1,1-Trichloroethane due to explosion risk.
Ensure maintenance by qualified technicians using original parts; check for damaged parts.
Clean the gun with thinner before and after use; disassemble and soak if clogged.
Adjust inlet air pressure using the regulator knob to ensure peak performance.
Use Air Volume and Fluid Volume controls to adjust air/fluid ratio for different paints.
Adjust spray pattern shape and orientation using dedicated control knobs.
Address half-moon patterns by cleaning air holes on the air nozzle.
Fix irregular patterns by cleaning or replacing the needle/fluid nozzle and air nozzle.
Resolve spitting by refilling the cup, tightening the nozzle, or replacing packing/parts.
Fix bubbling by cleaning/tightening the fluid or air nozzle.
Product is warranted against defects in materials/workmanship for up to one year.
Excludes consumables, misuse, neglect, accidents, and unauthorized alterations.
Excludes consequential, incidental, or special damages; remedy is repair or replacement.
General| Brand | Performance Tool |
|---|---|
| Model | H.V.L.P. Spray Gun |
| Category | Paint Sprayer |
| Language | English |
To Next Page
