Why is material in my Performance Tool Paint Sprayer cup bubbling?
If the material in the Performance Tool Paint Sprayer cup bubbles or 'boils', it could be due to a loose, clogged, or damaged Fluid Nozzle. Try cleaning, tightening, or replacing it. It may also be caused by a loose, clogged, or damaged Air Nozzle, so clean, tighten, or replace that as well.
What to do if my Performance Tool M711 is spitting?
Spitting from your Performance Tool Paint Sprayer can occur if there's too little material in the cup; refill the cup. It could also be due to a loose Fluid Nozzle; tighten the nozzle. Damaged Needle Packing can also cause spitting, so replace the packing. Finally, a dirty or damaged Needle & Nozzle Set can be the culprit; clean or replace the parts.
Why Performance Tool M711 has irregular pattern?
An irregular or offset pattern from your Performance Tool Paint Sprayer can be caused by a dirty or damaged Needle tip or Fluid Nozzle; clean or replace these parts. Another cause may be clogged atomization holes on the Air Nozzle around the center; clean the Air Nozzle.
How to fix half-moon shaped pattern with Performance Tool M711?
A half-moon shaped pattern from your Performance Tool Paint Sprayer indicates clogged air holes on the Air Nozzle ears. Carefully clean out the holes with wire after soaking in thinner.
Details key operational parameters including air pressure, spray pattern width, fluid inlet, and air consumption.
Comprehensive safety rules for operation, work area, personal protection, and hazard avoidance.
Instructions for cleaning the spray gun after use to prevent corrosion and maintain internal parts.
Step-by-step guide on connecting and regulating air pressure for optimal gun performance.
How to adjust air and fluid flow rates to achieve the correct paint ratio for spraying.
Techniques for adjusting the spray pattern's form and direction for desired coverage.
Visual diagram and list of numbered parts for identifying and ordering replacements.
Solutions for common spray pattern defects like half-moon or offset patterns caused by clogs or damage.
Diagnosing and resolving spitting, material bubbling, or boiling issues during operation.
Details on warranty coverage, exclusions, and the process for making a claim.
General| Nozzle Size | 1.4 mm |
|---|---|
| Maximum Pressure | 40 PSI |
| Type | HVLP |
| Power Source | Compressed Air |
| Air Inlet | 1/4 inch |
To Next Page
