How to fix irregular or offset pattern with Performance Tool M708 Paint Sprayer?
An irregular or offset pattern from your Performance Tool Paint Sprayer could be due to a dirty or damaged needle tip or fluid nozzle; clean or replace these parts. It could also be caused by clogged atomization holes on the air nozzle around the center, so cleaning the air nozzle is recommended.
What to do if material in cup bubbles or “Boils” in Performance Tool M708?
If the material in the cup of your Performance Tool Paint Sprayer is bubbling or boiling, the fluid nozzle or air nozzle may be loose, clogged, or damaged. Try cleaning, tightening, or replacing the fluid nozzle. Also, clean, tighten, or replace the air nozzle.
Why Performance Tool M708 Paint Sprayer is spitting?
Your Performance Tool Paint Sprayer might be spitting due to several reasons. First, check if there is too little material in the cup and refill it if needed. Second, ensure the fluid nozzle is tightened properly. Third, a damaged needle packing could be the cause, in which case you should replace it. Finally, a dirty or damaged needle and nozzle set can cause spitting, so clean or replace these parts.
What to do if Performance Tool Paint Sprayer has half-moon shaped pattern?
If your Performance Tool Paint Sprayer is producing a half-moon shaped pattern, this is likely due to clogged air holes on the air nozzle ears. Carefully clean out these holes with wire after soaking the nozzle in thinner.
Covers work area, personnel, operation, and impairment.
Addresses ignition sources, air source, paint materials, and solvent hazards.
Covers disconnection, part checks, and regular maintenance.
Includes Proposition 65 and general operational disclaimers.
Adjusting air pressure using the regulator knob.
Adjusting air and fluid output for paint ratio.
Adjusting pattern shape and orientation.
Troubleshooting guide for a specific spray pattern issue.
Troubleshooting guide for pattern irregularities.
Troubleshooting guide for spitting issues.
Troubleshooting guide for material bubbling.
General| Maximum Operating Pressure | 50 PSI |
|---|---|
| Nozzle Size | 1.4 mm |
| Material Cup Capacity | 600 cc |
| Air Inlet Size | 1/4 inch |
| Type | HVLP |
| Power Source | Air Powered |
To Next Page
