EasyManua.ls Logo

Performance Tool M706 - User Manual

Performance Tool M706
8 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Gravity Feed HVLP Spray Gun
OWNER’S MANUAL
Stock Numbers M706 & M707
FOR YOUR SAFETY,
please read these instructions carefully and retain them for future use.

Table of Contents

Questions and Answers

  • R
    Roy JenkinsJul 27, 2025
    What to do if Performance Tool M706 Paint Sprayer is spitting?
    • A
      Anthony Burnett DDSJul 27, 2025
      Spitting from your Performance Tool Paint Sprayer can occur if there's too little material in the cup; simply refill the cup. It may also happen if the Fluid Nozzle is loose; make sure to tighten it. Damaged Needle Packing can also cause spitting, so replace the packing if necessary. Lastly, a dirty or damaged Needle and Nozzle Set can be the culprit; clean or replace these parts to resolve the issue.
  • M
    mary39Aug 4, 2025
    Why Performance Tool Paint Sprayer has irregular or offset pattern?
    • C
      curryclaytonAug 4, 2025
      An irregular or offset pattern from your Performance Tool Paint Sprayer could be due to a dirty or damaged Needle tip or Fluid Nozzle. Try cleaning or replacing the Needle or Fluid Nozzle. Another cause could be clogged atomization holes on the Air Nozzle around the center. Cleaning the Air Nozzle may resolve this.
  • A
    andrea11Aug 11, 2025
    How to fix half-moon shaped pattern with Performance Tool M706?
    • J
      Jennifer RichardsAug 11, 2025
      A half-moon shaped pattern from your Performance Tool Paint Sprayer is caused by clogged air holes on the Air Nozzle ears. Carefully clean out these holes with wire after soaking in thinner to resolve the issue.
  • E
    ericksonjustinAug 19, 2025
    Why is material in the Performance Tool M706 Paint Sprayer cup bubbling or boiling?
    • C
      Cindy HunterAug 19, 2025
      Bubbling or boiling material in the Performance Tool Paint Sprayer cup can result from a Fluid Nozzle that is loose, clogged, or damaged. To resolve this, try cleaning, tightening, or replacing the Fluid Nozzle. Another potential cause is a loose, clogged, or damaged Air Nozzle. In this case, you should clean, tighten, or replace the Air Nozzle.

Summary

Specifications

HVLP Compliance Notice

Explains the High Volume Low Pressure compliance and its benefits for transfer efficiency.

Important Safety Information

General Safety Warnings

Crucial warnings for safe operation, including PPE, fire hazards, and chemical risks.

Maintenance and Inspection

Cleaning and Air Source Maintenance

Guidelines for cleaning the spray gun and maintaining a clean air source for peak performance.

Part Inspection and Replacement

Instructions for inspecting critical parts like needles and nozzles for damage or wear.

Operation

Inlet Air Pressure Regulation

Details on setting and adjusting the inlet air pressure using the regulator control knob.

Air and Fluid Volume Controls

Explanation of how to adjust air and fluid volume for optimal spraying results.

Spray Pattern Control

Guide to adjusting spray pattern shape and orientation for different applications.

Parts Drawing

Parts Identification and Drawing

Diagram and list identifying all components of the spray gun for reference and replacement.

Troubleshooting

Troubleshooting Common Spray Issues

Identifies common spray problems, their probable causes, and suggested solutions.

Warranty

Limited Warranty Terms and Exclusions

Outlines the warranty coverage, exclusions, limitations, and legal rights.

Performance Tool M706 Specifications

General IconGeneral
BrandPerformance Tool
ModelM706
CategoryPaint Sprayer
LanguageEnglish

Related product manuals