Read all safety warnings before operation.
WARNING!
All persons in the work area must always wear approved eye and ear protection and
approved breathing apparatus when this spray gun is in operation.
Never aim spray gun at anyone. Do not spray near sparks, open flame, lit cigarettes, pilot
lights, space heaters or any other potential ignition source. DO NOT SMOKE IN WORK
AREA.
Follow manufacturers instructions and safety information to ensure safe handling and
proper use of paints, lacquers, thinners, base coats, etc. Do not use latex or other heavy
paints. They are not recommended for this spray gun.
Warning! Solvents 1,1,1-Trichloroethane and Methylene Chloride (Dichlormethane - some-
times called Methylchloride) can chemically react with the Aluminum used in most spray
equipment creating an explosion hazard. Read the label or data sheet from the mate-
rial you intend to spray. NEVER USE ANY MATERIAL CONTAINING THESE SOLVENTS. If
unsure as to the composition of your material, check with your supplier. Do not use acids
for cleaning.
Always keep work area free from obstructions and well ventilated.
Always disconnect spray gun from air source before disassembly.
SPECIFICATIONS
IMPORTANT SAFETY INFORMATION
3
WARNING!
Failure to heed these warnings may result in personal injury or property damage.
Specifications are subject to change without notice
*
Operating Pressure 15 - 45 PSI
Spray pattern 3" - 7"
Spray Head & Needle 1.3 mm (M706 & M707)
1.5 mm (M706 & M707)
1.7 mm (M707)
Cup capacity 1000 ml.
Avg. air consumption 7.0 - 9.0 CFM
Fluid inlet 3/8" NPS
Air inlet 1/4" NPS
Hose size 3/8" I.D.
Controls:
• Spray pattern, fluid flow and inlet air pressure
• All purpose gun sprays primers, base coats, sealers,
clear coats
• Fully adjustable spray pattern
• Locking pressure regulator with pressure gauge
• 1000 ml paint cup
• Includes wall hanger, multi-wrench, cleaning brush,
socket and fluid filter
HVLP NOTICE
This High Volume Low Pressure
(HVLP) compliant spray gun was
designed to provide maximum transfer
efficiency by limiting air cap pressure
to 10 PSI when used properly.
To maintain a maximum air cap
pressure of 10 PSI at the nozzle,
use a maximum of 36 PSI at the inlet.
*
To Next Page
Loading...
Need help?
General
