To Next PageTo Next PageHow to fix a half-moon shaped pattern with Performance Tool M578DB?
A half-moon shaped pattern from your Performance Tool Paint Sprayer is caused by clogged air holes on the Air Nozzle ears. Carefully clean out the holes with wire after soaking in thinner.
Why is the material in the Performance Tool M578DB cup bubbling?
If the material in the cup of your Performance Tool Paint Sprayer bubbles or "boils", it could be due to a loose, clogged, or damaged Fluid Nozzle or Air Nozzle. Try to clean, tighten, or replace the Fluid Nozzle. Also, clean, tighten, or replace the Air Nozzle.
What to do if my Performance Tool M578DB is spitting?
Spitting from your Performance Tool Paint Sprayer can happen if there's too little material in the cup, the Fluid Nozzle is loose, the Needle Packing is damaged, or the Needle & Nozzle Set is dirty or damaged. Refill the cup, tighten the Nozzle, replace the Packing, or clean/replace the parts to resolve the issue.
Why does my Performance Tool M578DB have an irregular pattern?
An irregular or offset pattern from your Performance Tool Paint Sprayer could be due to a dirty or damaged Needle tip or Fluid Nozzle, or clogged atomization holes on the Air Nozzle. Clean or replace the Needle or Fluid Nozzle. Also, clean the Air Nozzle.
General| Maximum Pressure | 3000 PSI |
|---|---|
| Hose Length | 25 ft |
| Spray Tip Size | 0.015 in |
| Voltage | 120 V |
| Type | Airless |
| Motor Power | 0.5 HP |
Critical instructions to prevent injury and property damage before operating the tool.
Setting inlet air pressure for optimal spray gun performance and adjustments.
Adjusting fluid volume output using the control knob for desired spray results.
Adjusting spray pattern shape and orientation for desired finish.
Instructions for cleaning the spray gun before and after each use and general maintenance.
Addressing spray patterns caused by clogged air holes on the air nozzle ears.
Resolving spray patterns due to dirty/damaged needle/nozzle or clogged atomization holes.
Fixing spitting issues caused by low material, loose nozzle, or damaged packing.
Troubleshooting bubbles or boiling in the paint cup due to nozzle issues.
