OPERATION
5
Air and Fluid Volume Controls - These two controls are used
in conjunction with each other to accurately adjust air/fluid (Paint)
ratio and will vary for different paints. Changing one control
affects the other so alternating back and forth between them to
fine tune your adjustment will yield optimum results.
Air Volume Control - Air volume is adjusted by turning the Air
Control Knob. Turning knob in reduces volume, turning knob out
increases volume.
Fluid Volume Control - Fluid volume is adjusted by turning the
Fluid Volume Control Knob. Turning knob in decreases volume,
turning knob out increases volume. Once a satisfactory volume is
set, you can lock the adjustment by turning the lock nut in tight.
Spray Pattern Control
Pattern Shape - The shape of the spray can be adjusted from
a round pattern to a flat pattern by turning the Pattern Control
Knob. Turning knob in rounds the pattern, turning knob out
flattens the pattern.
Pattern Orientation - A flat or semi-round spray pattern can be
adjusted to any angle from horizontal to vertical by turning the
Air Nozzle. Pattern is perpendicular to “ears” on nozzle. That is,
when the ears are horizontal, the spray pattern will be vertical
and when the ears are vertical the spray pattern will be
horizontal.
Fluid Volume
Control Knob
Fluid Volume
Lock Nut
Air Volume
Control Knob
Air
Nozzle
Spray Pattern
Control Knob
Fluid Volume
Control Knob
Fluid Volume
Lock Nut
Air Volume
Control Knob
Air
Nozzle
Spray Pattern
Control Knob
STEP 2.
STEP 3.
To Next Page
Loading...
Need help?
General
