TORQUE SETTING
PUSH COLLAR TOWARD
RATCHET HEAD TO
•UNLOCK•
TURN THE HANDLE
CLOCKWISE TO
INCREASE THE TORQUE
TURN THE HANDLE
PULL COLLAR TOWARD
CCW TO DECREASE
THE TORO-UE
HANDLE TO
•LOCK'
1 .Push collar toward ratchet head to "UNLOCK"
2.Turn the handle Clockwise or Counterclockwise(Right or
Left) to set the desired torque.
3.Pull collar toward handle to "LOCK"
EXAMPLES OF TORQUE SETTINGS
To set torque to 83 ft.lbs. turn the handle clockwise until the edge
of the minor scale is even with the line marking "80" on the major
scale and the "O ft.lb."mark on the minor scale is centered as
shown in fig. 1 below. Then, continue turning the handle clockwise
until the "3 ft.lb." mark is centered as shown in fig.2.
80 FT.LBS
(too FT.LBS WRENCH)
00 r
83 FT-LBS
too FT-LBS WRENCH)
210 FT.LES
(250
212
(250 FT.CBS
34 NV
205 INLBS
WRENCH)
208
(250 WRENCH)
Various models and capacities of wrenches are illustrated.
Though they might be different from your particular wrench,
the principle of obtaining scale reading is the same.
*'By necessity, metric scales are not calibrated in even numbers.
Consequently,when using Metric scales, set the wrench at a
reading closest to the desired torque.
To Next Page
Loading...
