GENERAL CUTTING
1. Clearly mark the workpiece to locate
the position of the cut.
2. Hold smaller workpieces with a vice.
Clamp larger workpieces to a
workbench or table.
DANGER: Any workpiece that is
not adequately clamped in place may
come loose and cause serious injury.
Never hold the workpiece with your
hand.
For safety reasons, the operator must
read the sections of this Owner’s
Manual entitled “GENERAL SAFETY
WARNINGS”, “POWER TOOL
SAFETY”, “SPECIFIC SAFETY
RULES”, “BATTERY AND CHARGER
SAFETY” and “SYMBOLS” before
using this cordless reciprocating saw.
Verify the following every time the
cordless reciprocating saw is used:
1. The blade is sharp and in good
condition.
2. The blade is firmly clamped in the
blade holder.
3. The workpiece is properly
secured.
4. Safety glasses and hearing
protection are being worn.
Failure to observe these safety rules
will significantly increase the risk of
injury.
To Next Page
Loading...
Need help?
General