Note: Some oil filters may be installed horizontally.
Refer to illustration 50 . This type of oil filter assembly
can be drained before the filter is removed. The
torque for this drain plug (4) is 12 N·m (8 lb ft). If
necessary, install a new O ring seal (5). Start at step
1 in order to remove the oil filter and install the oil
filter.
Illustration 50 g01169166
Typical example
Fill the Oil Pan
1. Remove the oil filler cap. Refer to this Operation
and Maintenance Manual, “Fluid
Recommendations” for more information on
suitable oils. Fill the oil pan with the correct
amount of new engine lubricating oil. Refer to this
Operation and Maintenance Manual, “Refill
Capacities” for more information on refill
capacities.
NOTICE
If equipped with an auxilliary oil filter system or a re-
mote filter system, follow the OEM or the filter manu-
facture's remonmendations. Under filling or over
filling the crankcase with oil can cause engine
damage.
2. Start the engine and run the engine at “LOW IDLE”
for two minutes. Perform this procedure in order to
ensure that the lubrication system has oil and that
the oil filters are filled. Inspect the oil filter for oil
leaks.
3. Stop the engine and allow the oil to drain back to
the oil pan for a minimum of ten minutes.
Illustration 51 g01165836
(Y) “Min” mark. (X) “Max” mark.
4. Remove the engine oil level gauge in order to
check the oil level. Maintain the oil level between
the “MIN” and “MAX” marks on the engine oil level
gauge.
i02761883
Engine Oil and Filter - Change
(CG-4 Oil)
CG-4 oil may be used on some engines. The power
of the engine must be less than 168 kW (225 hp). If
this grade of engine oil is used a 250 hour service
interval is required on the engine oil and the engine
oil filter.
For more information refer to this Operation and
Maintenance Manual, “Fluid Recommendations”.
Use the same service procedure as the standard 500
hours service procedure in order to change the
engine oil and the engine oil filter.
i02348484
Engine Valve Lash - Inspect/
Adjust
This maintenance is recommended by Perkins as
part of a lubrication and preventive maintenance
schedule in order to help provide maximum engine
life.
SEBU8119-04
85
Maintenance Section
Engine Oil and Filter - Change
To Next Page
Loading...
