• Failure to use recommended fuel, lubricants and
coolant/antifreeze
i07888480
Starting Motor - Inspect
Perkins recommends a scheduled inspection of the
starting motor. If the starting motor fails, the engine
may not start in an emergency situation.
Check the starting motor for correct operation. Check
the electrical connections and clean the electrical
connections. Refer to the Systems Operation, Testing
and Adjusting Manual, “Electric Starting System -
Test” for more information on the checking procedure
and for specifications consult your Perkins dealer or
your Perkins distributor for assistance.
i04149590
Turbocharger - Inspect
A regular visual inspection of the turbocharger is
recommended. If the turbocharger fails during engine
operation, damage to the turbocharger compressor
wheel and/or to the engine may occur. Damage to
the turbocharger compressor wheel can cause
additional damage to the pistons, the valves, and the
cylinder head.
NOTICE
Turbocharger bearing failures can cause large quan-
tities of oil to enter the air intake and exhaust sys-
tems. Loss of engine lubricant can result in serious
engine damage.
Minor leakage of oil into a turbocharger under ex-
tended low idle operation should not cause problems
as long as a turbocharger bearing failure has not
occured.
When a turbocharger bearing failure is accompanied
by a significant engine performance loss (exhaust
smoke or engine rpm up at no load), do not continue
engine operation until the turbocharger is renewed.
A visual inspection of the turbocharger can minimize
unscheduled downtime. A visual inspection of the
turbocharger can also reduce the chance for potential
damage to other engine parts.
Removal and Installation
For options regarding the removal, installation, and
replacement, consult your Perkins dealer or your
Perkins distributor. Refer to the Disassembly and
Assembly, “Turbocharger - Remove and
Turbocharger - Install” and Systems Operation,
Testing and Adjusting, “Turbocharger - Inspect” for
further information.
Inspecting
NOTICE
The compressor housing for the turbocharger must
not be removed from the turbocharger for inspection
or removed for the cleaning of the compressor.
1. Remove the pipe from the turbocharger exhaust
outlet and remove the air intake pipe to the
turbocharger. Visually inspect the piping for the
presence of oil. Clean the interior of the pipes in
order to prevent dirt from entering during
reassembly.
2. Check for obvious heat discoloration of the
turbocharger. Check for any loose bolts or any
missing bolts. Check for damage to the oil supply
line and the oil drain line. Check for cracks in the
housing of the turbocharger. Ensure that the
compressor wheel can rotate freely.
3. Check for the presence of oil. If oil is leaking from
the back side of the compressor wheel, there is a
possibility of a failed turbocharger oil seal.
The presence of oil may be the result of extended
engine operation at low idle. The presence of oil
may also be the result of a restriction of the line for
the intake air (clogged air filters), which causes the
turbocharger to slobber.
4. Inspect the bore of the housing of the turbine outlet
for corrosion.
SEBU8119-04
99
Maintenance Section
Starting Motor - Inspect
To Next Page
Loading...
