EasyManua.ls Logo

Perkins 1206D-E70TTA - Page 57

Perkins 1206D-E70TTA
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The Oil Condition Analysis determines the loss of
the oils lubricating properties. An infrared analysis
is used to compare the properties of new oil to the
properties of the used oil sample. This analysis
allows technicians to determine the amount of
deterioration of the oil during use. This analysis
also allows technicians to verify the performance
of the oil according to the specification during the
entire oil change interval.
i07329421
Fluid Recommendations
(General Fuel Information)
Glossary
ISO International Standards Organization
ASTM American Society for Testing and Materials
HFRR High Frequency Reciprocating Rig for
Lubricity testing of diesel fuels
FAME Fatty Acid Methyl Esters
CFR Co-ordinating Fuel Research
LSD Low Sulfur Diesel
ULSD Ultra Low Sulfur Diesel
RME Rape Methyl Ester
SME Soy Methyl Ester
EPA Environmental Protection Agency of the
United States
General Information
NOTICE
Every attempt is made to provide accurate, up-to-
date information. By use of this document you agree
that Perkins Engines Company Limited is not respon-
sible for errors or omissions.
NOTICE
These recommendations are subject to change with-
out notice. Contact your local Perkins distributor for
the most up-to-date recommendations.
Diesel Fuel Requirements
Perkins is not in a position to evaluate continuously
and monitor all worldwide distillate diesel fuel
specifications that are published by governments and
technological societies.
Perkins Specification for Distillate Diesel Fuel in table
14 provides a known reliable baseline to judge the
expected performance of distillate diesel fuels that
are derived from conventional sources.
Satisfactory engine performance depends on the use
of a good quality fuel. The use of a good quality fuel
will give the following results: long engine life and
acceptable exhaust emissions levels. The fuel must
meet the minimum requirements that are stated in
table 14 .
NOTICE
The footnotes are a key part of the Perkins Specifica-
tion for Distillate Diesel Fuel Table. Read ALL of the
footnotes.
M0090743
57
Maintenance Section
Fluid Recommendations

Table of Contents

Related product manuals