Indicator Lamps
• Shutdown lamp
• Warning lamp
• Wait to start lamp
• Low oil pressure lamp
For information, refer to this manual, “Monitoring
System (Table for the Indicator Lamps)” for the
sequence of operation of the shutdown lamp and the
warning lamp.
The function of the wait to start lamp is automatically
controlled at engine start-up.
The function of the low oil pressure lamp is controlled
by the engine ECM. If low oil pressure is detected,
the lamp will be illuminated. The reason for the
illumination of the low-pressure lamp should be
investigated immediately.
All lamps will illuminate for 2 seconds in order to
check that the lamps are functioning when the
keyswitch is turned to the ON position. If any of the
lamps stay illuminated, the reason for illumination
should be investigated immediately.
Aftertreatment Lamps
For information on the aftertreatment lamp, refer to
this Operation and Maintenance Manual, “Diesel
Particulate Filter Regeneration”.
SEBU8601-04
37
Operation Section
Gauges and Indicators
To Next Page
Loading...
