Illustration 47 g06474305
1. Position the new alternator belt onto the alternator
pulley. Refer to Operation and Maintenance
Manual, “Alternator and Fan Belts - Replace” for
the correct procedure.
2. Use a suitable tool to position the alternator away
from the cylinder block engage the cut-out in
Position (X) in link lever (2) with bolt (3). Tighten
bolt (3).
Illustration 48 g06474149
3. Tighten bolt (1), bolt (5), and bolt (3) in the
sequence shown in Illustration 48 to a torque of
22 N·m (195 lb in)
4. If the engine is equipped with fan guards, install
the fan guards. Refer to the Original Equipment
Manufactures (OEM) for the correct procedure.
Engines Equipped with a Balancer
If the engine is equipped with Balancer, the alternator
is supplied by the OEM. Refer to the OEM for the
correct removal and installation procedures.
82 M0094137-02
Maintenance Section
Multi-V Stretch Belt
To Next Page
Loading...
