WARNING:
●Avoid potential personal injury or property damage! Do not use a drill for
tightening the lag screws! Only use a socket wrench. DO NOT over-tighten
the lag screws [A1]. Tighten the lag screws [A1] only until they are pulled
firmly against the wall plate.
●Ensure the arm assembly / wall plate [01B] is securely
fastened to the wall before continuing to the next step.
● Any material covering the wall must not exceed 5/8” (16mm).
● Mount the arm assembly / wall plate [01B] directly onto the concrete surface.
● Minimum solid concrete thickness: 8” (203mm).
● Minimum concrete block size: 8 x 8 x 16” (203 x 203 x 406mm).
● Never drill into the mortar between blocks.
Step 3B Solid Concrete or Concrete Block Option
3A-4
Position the arm assembly /
wall plate [01B] at your
desired height, level the wall
plate and mark the 4 pilot
hole locations.
3B-1
7/16” (11mm)
Socket Wrench
(Not Included)
UP
1
3
4
2
Wall
Anchor
A2
Install the arm assembly / wall plate
[01B] using lag screws [A1]. Tighten the
lag screws [A1] only until they are pulled
firmly against the wall plate.
A1
01B
UP
01 02 03 04 05 06 07 08 09 10 11
12 13 14 15 16 17 18 19 20 21 22
23 24 25 26 27 28 29 30 31 32 33
34 35 36 37 38 39 40 41 42 43 44
45 46 47 48 49 50 51 52 53 54 55
To Next Page
Loading...
