Perlesmith PSLF7 - Page 10

Drill 4 pilot holes using a
3/8 in.(10mm)diameter drill bit.
Make sure the depth is not less
than 2 3/4 in.(70mm). Never drill
into the mortar between blocks.
3/8 in.(ø10mm)
2 3/4 in.(70mm)
Use the hammer to
knock anchors [A3]
into the wall. Be sure
the anchors [A3] are
seated flush with the
concrete surface.
Install the arm assembly/wall plate [05] using lag
screws [A1], washers [A2] and anchors [A3]. Tighten
the lag screws [A1] only until the washers [A2] are
pulled firmly against the wall plate. DO NOT
over-tighten the lag screws [A1].
3B-2
3B-3
A3
A2
A1
Step 4 Secure the TV onto the Arm Assembly/Wall Plate [05]
1. Hang the TV onto the front support assembly.
2. Tighten the lock bolts [S] to secure TV onto the arm assembly/wall
plate [05] using screwdriver
①
Locking
②
S
1/2 in.(13mm)
Socket Wrench
HEAVY! You may need
assistance with this step.
HEAVY! You may need
assistance with this step.
09