What to do if my Perma Lubrication system displays an error at a lubrication point?
If your Perma Lubrication system displays an error at the lubrication point, it is likely due to excess motor current caused by a blockage at the displayed outlet. The solution is to clear the blockage and then acknowledge the fault by pushing and holding down the ON/ OFF/SELECT button.
What to do if my Perma Lubrication system has been switched off?
Your Perma Lubrication system might be switched off due to several reasons. One potential cause is excess motor current in the perma MP-6. If this is the case, replace the perma MP-6 distributor. Other possible causes include incorrectly recognized distributor outlets, in which case you should replace the distributor. A timeout while activating the distributor or a damaged connection cable could also be the reason; in these cases, replace the distributor or the connection cable, respectively.
Why has my Perma Lubrication system been switched off?
The Perma Lubrication system might have been switched off because of excess motor current of the lubricator motor due to a blocked outlet or an empty battery set. Clear the blockage and acknowledge the fault by pushing and holding down the ON/ OFF/SELECT button. If the battery set is empty, insert a new battery set and use a full PRO LC unit. Another reason for this issue can be a defective drive mechanism. In this case, exchange the drive unit.
What to do if no power is supplied to my Perma Lubrication system from the battery?
If no power is being supplied to your Perma Lubrication system from the battery, the cause is likely that no battery is inserted or the battery set is empty. To resolve this, insert a new battery set and use a full PRO LC unit.
What to do if the Perma Lubrication system does not detect the PRO LC unit?
If the Perma Lubrication system does not detect the PRO LC unit, ensure that a PRO LC unit is installed. If it is not, install an PRO LC unit.
What to do if the Perma Lubrication system outlet configuration is missing?
If the outlet configuration is missing in your Perma Lubrication system, it is probably because the outlets were not activated. To fix this, activate the desired outlets.
General| Brand | Perma |
|---|---|
| Model | PRO C 250 |
| Category | Lubrication systems |
| Language | English |
To Next Page
