Why is the red LED flashing 'OL' on my Perma Lubrication system?
The red LED flashing and the display showing 'OL' on your Perma Lubrication system indicates that the counter-pressure has exceeded 6 bar for an extended period. To resolve this, check for and remove any blockages to reduce the counter-pressure to below 6 bar. After resolving the blockage, press the SET button.
What to do if the display on my Perma Lubrication system O 1 2 5 is not showing anything even with a new battery?
If the display on your Perma Lubrication system is blank even after inserting a new battery, it's possible that the drive is defective. In this case, you should replace the drive.
What to do if the red LED is flashing 'LC' on my Perma Lubrication system U LC 250 DAYS, even though the LC is not empty?
If the red LED is flashing 'LC' on your Perma Lubrication system, even when the LC is not empty, ensure that you have selected the correct LC size. Replace the LC with the correct size.
What to do if the green LED is flashing on my Perma Lubrication system U T LC 120 / 60 even though the LC is empty?
If the green LED is flashing on your Perma Lubrication system when the LC is empty, make sure that the correct LC size is selected. Replace the LC with the appropriate size.
Why is the LED flashing 'ut' on my Perma Lubrication system?
The LED flashing 'ut' on your Perma Lubrication system indicates that the permitted temperature has been undershot for a prolonged period. Ensure that the permitted temperature is maintained, then press the SET button.
General| Lubricant Volume | 60 cm³, 120 cm³, 250 cm³ |
|---|---|
| Temperature Range | -20°C to +60°C |
| Operating Temperature | -20°C to +60°C |
| Drive | Electromechanical |
| Pump Type | Piston Pump |
| Protection Class | IP65 |
| Material | Plastic |
| Lubricant | Greases up to NLGI 2, oils |
| Control | Microprocessor controlled |
| Discharge Periods | 1 - 12 months |
| Setting | Via DIP switch |
To Next Page
