Permobil F3 Corpus - Page 84

F3 Corpus
Getting to know your wheelchair
Programming
The following section describes submenus related to Programming.
Sleep Sets the time after which the control system will
go to sleep if an input device command is not
received.
Sounder Volume Sets the volume of the sounder used to indicate
button presses.
Horn Volume Sets the volume of the horn.
Start-up Beep
Sets whether or not the controller emits a short
beep when turned on. Available only in later
versions of the control panel.
Momentary Screens
Sets whether programmed Momentary Screens
are displayed.
Display Speed Sets how the wheelchair's speed is displayed;
options are mph, km/h or Off.
Displays Sets the format of the digital drive display; the
options are odometer, speed or both.
84