EasyManua.ls Logo

Peterbilt 330 - Steering Column and Mirrors; Introduction; Turn Signal;High Beam Switch

Peterbilt 330
248 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Instructions Steering Column and Mirrors
Model 330 PB1318 3/01
– 51 –
STEERING COLUMN AND MIRRORS
Introduction
This section covers the standard steering column controls
and mirror operation. Depending on how your Model 330 is
configured, some or all of these features are installed on your
vehicle.
Turn Signal/High Beam Switch
NOTE: The ignition key must be turned to
IGN &
ACC
for the signal/switch to operate.
The lever-action turn signal/high beam switch is
located on the left side of the steering column.
Turn Signals
To signal a right turn, push the lever up (clockwise).
To signal a left turn, push the lever down (counterclock-
wise).
WARNING! After you complete a turn, make sure
the turn signal system is turned off by returning
the lever to the “OFF” (center) position. The
switchs lever action is NOT self-cancelling. Fail-
ure to shut off a turn signal could confuse other
drivers and result in an injury accident. An indi-
cator light in the instrument panel will flash until
the turn signal is turned off.
Steering Column Controls
02596
TURN
SIGNAL/HIGH
BEAM SWITCH
EMERGENCY FLASHER
TRAILER
BRAKE VALVE

Table of Contents

Related product manuals