8
Install the main unit
1. Place the main unit on a level surface.
2. Press and hold the PUSH button and place the circular notches on both sides of the
food storage container downward toward the PUSH buttons until the PUSH button is
fully stuck into the circular notches. (As shown in the figure below).
3. Take the stainless-steel food bowl and place it in the food bowl stand.
Install the backup batteries. (If you want to install batteries, you will need to
buy the batteries separately).
(Before installing batteries, make sure there is no food in the storage container.)
1. Take out the screw and remove the battery cover.
2. Take 5AAA batteries and place them in the battery compartment. (Pay attention to
the orientation of the positive and negative ends.)
3. Put the battery cover back on and tighten down the screw.
We strongly recommend checking and replacing the batteries before leaving the device
unattended for and extended period of time. Always replace batteries that have a low charge.
(Only use alkaline batteries)
Scan QR code to see
an instructional video
for installation
To Next Page
Loading...
