A1 A2
A3 A4
A5 A6
B3
B1 B2
READ AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS THAT COME WITH THIS KENNEL.
To assemble kennel:
A1. Wire kennel comes collapsed, in locked position with plastic pan installed.
Lay kennel at on any non-scuff surface and locate lock wire. Lock wire
should be pointing up for proper assembly position.
A2. Unlock wire kennel by pulling lock wire down. Fold out top kennel panel.
A3. Grab overhanging panel, lift up and swing over to form main structure
of kennel.
A4. Reach in and pull up door panel. Door panel has 4 side wall latches and
two top panel corner locks. Make sure all are secured.
A5. Once complete, engage top panel center latch over top side of kennel.
Follow same procedure to secure back panel of kennel.
A6. Open door by raising latch mechanism all the way up and pushing over.
Always make sure door is properly secured when animal is inside.
To remove plastic pan:
B1. Lift front door panel up so that pan-locking device can slide under the front
door panel.
B2. Slide pan out from front of kennel.
B3. Reverse steps to reengage pan-locking device.
Note: Do not let pet inside kennel without pan-locking device engaged.
WARNING: Do not let animal in kennel without pan in place. Do not try to
remove pan any other way, for risk of damaging or breaking of pan. Do not let
pet inside kennel with a broken pan. Be sure pan-locking device is engaged
while pet is inside kennel. Do not remove/replace tray while animal is inside.
For information on ordering a replacement pan, go to petmate.com or
call 1-877-738-6283.
Doskocil Manufacturing Company, Inc. d/b/a Petmate
PO Box 1246, Arlington, TX 76004-1246
1-877-738-6283
© Doskocil Manufacturing Company, Inc. d/b/a Petmate 2011
pet home
training kennel
™
instructions
To Next Page
Need help?
General
