3. First-time installation
Please read the Safety Information chapter prior to first use
1. Connect the PetPace Gateway (item 3) to the power supply.
a. Insert the micro USB connector of the power cable (item 4) to the
gateway.
b. Connect the USB type-A connector of the power cable (item 4) to the
USB power supply adapter (item 6).
c. Connect the USB power supply adapter (item 6) to a power outlet.
d. Once the PetPace Gateway is connected to power, the bottom green
LED light will blink.
2. Connect the PetPace Gateway (item 3) to the Internet.
a. Connect the Ethernet cable (item 5) to the Gateway's RJ-45 connector
on one side and to your Router/Modem LAN port on the other side.
b. Make sure your Router/Modem is connected to the Internet.
c. Once the PetPace Gateway is connected to the Router/Modem the
middle green LED light will blink.
3. Once the PetPace Gateway establishes a connection with the PetPace Servers
the bottom green LED will switch from blinking to being constantly ON.
4. You are now ready to start working with the PetPace Collar.
4. Charging the Collar
It is highly recommended to completely charge the collar before first use.
When the Collar's battery is low, the Collar's LED light will blink in red every 10
seconds. A low-level battery indicator will also show on the pet’s page on the Web
page or Mobile Application. To charge the collar when the battery is low, or before
first time use, please follow these steps:
1. Connect the Collar Charging Cable (item 2) to power outlet using the USB power
supply adapter (item 6).
2. If the collar is on the dog remove it and connect it to the Collar charging cable
(item 2). Make sure the charger pins are aligned with the collar’s charging
socket. Push charger gently into place until the wings snap into the slots on the
collar (see pictures below).
To Next Page
Loading...