7
4. Remove and Inspect the Filter:
Remove the filter from the housing
and inspect it for debris or damage.
3. Unthread the Filter Housing: Use
an adjustable wrench to unthread the
filter housing from the bottom of the
valve handle.
6. Replace if Necessary: If the filter is
damaged, replace it with a new one.
2. Remove the Hose: Carefully pull
the hose away from the valve handle
to disconnect it.
5. Clean the Filter: If the filter is dirty,
use a soft brush and clean water to
remove debris gently. Ensure it is
clean before reassembly.
7. Reassemble the Valve Handle:
Reinsert the filter into the housing,
thread the housing back onto the
valve handle, reconnect the hose, and
tighten the compression nut securely.
To Next Page
