www.petsafe.net 7
5. The Bark Control Collar should fi t snugly,
yet loose enough to allow one fi nger to fi t
between a Contact Point and your dog’s neck.
Allow your dog to wear the collar for several
minutes, then recheck the fi t. Check the fi t
again as your dog becomes more comfortable
with the Bark Control Collar.
6. Trim the collar as follows:
a. Measure 4 1/2” from the tongue of the metal buckle and mark with
a pen.
b. Remove the Bark Control Collar from your dog and cut off excess.
_________________________________________________________________
ID Tag Ring
Use the ID Tag
Ring to attach
your dog’s ID
tags to the collar.
Simply place
the ID Tag Ring
through one of
the holes on your
collar. Make
sure to place the Ring far enough from the receiver housing so that the
tags will not hit the Receiver or the Contact Points.
To Next Page
Loading...
