Why are the Power and Loop Indicator Lights off on my Petsafe Pet Care Product?
If the Power and Loop Indicator Lights are off on your Petsafe Pet Care Product, first check that the Power Adapter is properly plugged into the Fence Transmitter. If it is, try plugging it into another 120-volt outlet. If the lights still do not come on, the Fence Transmitter and/or Power Adapter may need to be replaced.
What to do if Petsafe Pet Care Product receiver collar activates inside the house?
If your Petsafe Pet Care Product receiver collar activates inside the house, try turning the Boundary Width Control knob counterclockwise to decrease the activation distance from the Boundary Wire. Also, ensure the Boundary Wire isn't too close to the house, as the signal can transmit through walls. Finally, confirm that Boundary Wires are twisted from the Boundary to the Fence Transmitter.
Why does Petsafe Pet Care Product receiver collar have to be held on top of the Boundary Wire to activate?
If the receiver collar of your Petsafe Pet Care Product has to be held on top of the Boundary Wire to activate, try replacing the battery. You can also adjust the Boundary Width Control knob clockwise to increase the activation distance. Another option is to adjust the Boundary Control Switch to another setting. If using a Double Loop, ensure Boundary Wires are separated by 3 to 5 feet.
What to do if the Power Light is on, the Loop Indicator Light is off, and the Fence Transmitter loop alarm is sounding for Petsafe Pet Care Product?
If the Power Light is on, but the Loop Indicator Light is off, and the Fence Transmitter loop alarm is sounding for your Petsafe Pet Care Product, ensure both ends of the Boundary Wire are securely plugged into the Boundary Wire Terminals, with 1/2 inch of exposed copper wire.
What to do if pet is not responding to the Static Correction of Petsafe Pet Care Product?
If your pet is not responding to the static correction from the Petsafe Pet Care Product receiver collar, test the Receiver Collar with the Test Light while walking toward the Boundary Wire. If the Test Light flashes, check the fit of the Receiver Collar. You might need to trim your pet’s fur where the Contact Points touch the neck or purchase longer Contact Points. It may also be helpful to repeat training steps to reinforce training.
How to fix an inconsistent signal on Petsafe Pet Care Product?
If you are experiencing an inconsistent signal with your Petsafe Pet Care Product, ensure the Fence Transmitter is at least 3 feet away from large metal objects or appliances. Also, make sure all Boundary Wire turns are gradual and that the Boundary Wire is not running parallel to and within 5 feet of electrical wires, neighboring containment systems, telephone wires, television or antenna cables, or satellite dishes.
Why Petsafe Pet Care Product receiver collar is not beeping or correcting?
If the receiver collar of your Petsafe Pet Care Product is not beeping or correcting, check the battery to ensure it is installed properly. Also, check that both lights are lit on the Fence Transmitter.
General| Product Type | In-Ground Fence |
|---|---|
| Model Number | RFA-67 |
| Brand | PetSafe |
| Waterproof Collar | Yes |
| Expandable | Yes |
| Wire Gauge | 20 Gauge |
| Wire Length | 500 ft |
| Maximum Coverage Area | 1/3 acre |
| Battery Life | Up to 3 Months |
| Pet Weight Range | 8 Pounds and Up |
First phase of training to familiarize the pet with boundary flags.
Second phase of training to introduce static correction and its location.
To Next Page