Why is my Petsafe YardMax Cordless In-Ground Fence receiver collar not beeping or correcting?
First, ensure the receiver collar is turned on and that the battery status lights are flashing every 4 seconds. If it still does not work, charge the receiver collar and run the ReadyTest® startup and PerfectFit diagnostic tests. Also, check that the fence transmitter power is on and the display is lit.
What to do if my pet reacts strongly to the static correction from Petsafe YardMax Cordless In-Ground Fence and has become fearful?
If your pet reacts strongly to the static correction and has become fearful, you should lower the static correction level. If the issue persists, suspend training and start again the next day.
What to do if Petsafe YardMax Cordless In-Ground Fence Pet Care Product receiver collar is beeping, but the pet is not responding to the static correction?
Ensure that the static correction level is set at 2 or above. Test the receiver collar with the test light while walking toward the boundary wire. If needed, increase the static correction level.
Why does my Petsafe YardMax Cordless In-Ground Fence Pet Care Product receiver collar activate inside the house?
Ensure that the boundary wire is not running within 15 ft of the house. If it is, adjust the boundary width setting to decrease the distance from the boundary wire where the receiver collar activates.
What to do if my Petsafe YardMax Cordless In-Ground Fence receiver collar is not charging?
Check that the charger is properly seated into the receiver collar jack.
What to do if my pet is able to cross the boundary wire without receiving a static correction in YardMax® mode (A) with Petsafe YardMax Cordless In-Ground Fence?
First, make sure the fence transmitter is set to YardMax® mode (A). Then, ensure the receiver collar should tone at a distance of 1 ft. above the pet’s neck height.
Why does my Petsafe YardMax Cordless In-Ground Fence receiver collar correct within the pet area in YardMax® mode (A)?
Check that the receiver activation height is not greater than 1½ ft. above the pet’s neck height when crossing the boundary wire. Also, readjust the boundary wires where they cross buried cables.
What to do if my Petsafe YardMax Cordless In-Ground Fence Pet Care Product receiver collar has to be held on top of the boundary wire to activate?
Charge the receiver collar. If using Traditional mode (B), press the up button to adjust the boundary width setting.
Why does my Petsafe YardMax Cordless In-Ground Fence receiver collar correct when the pet returns to the Pet Area in YardMax® mode (A)?
Check that the fence mode is set to YardMax® mode (A) and not mode (B). If the issue persists, reverse the wires connected to the fence transmitter.
What causes a wire problem with Petsafe Pet Care Product?
Check the boundary wire connections at the fence transmitter for proper connection. Also, check outside for broken or damaged boundary wires. You may also perform the System Test or the Wire Break Location Test.
Overview of the transmitter's buttons, LED display, and indicator icons.
Outlines the four key stages for setting up and using the pet containment system.
Key steps for installing the transmitter, charging the collar, and preparing the yard.
Details the features and ideal uses of the YardMax® mode for pet containment.
Explains the Traditional mode, including its ability to create off-limits areas.
Step-by-step instructions for using splice capsules to connect boundary wires.
Testing the collar and boundary in Traditional mode for proper setup and width.
Instructions for safely burying the boundary wire to protect it and ensure system integrity.
General| Type | In-Ground Fence |
|---|---|
| Power Source | Battery |
| Collar | Included |
| Neck Size | 6 - 28 inches |
| Number of Pets | Unlimited with additional collars |
| Waterproof Receiver | Yes |
| Correction Type | Static |
| Fence Wire Included | Yes |
| Battery Life | Up to 3 weeks |
| Wire Gauge | 20 gauge |
| Waterproof Rating | Waterproof Collar |
| Training Modes | Tone, Static |
| Number of Correction Levels | 5 |
To Next Page