www.petsafe.net 9
ON/OFF Battery Module
The Petsafe
®
Bark Control Collar is packaged with the battery module
installed in the “OFF” position. To activate the collar, use a coin to turn
the Battery Module counter clockwise until the arrow lines up with the
“ON” position. If the Petsafe
®
Bark Control Collar is not going to be used
on the dog immediately leave it in the “OFF” position.
To Insert and Remove the Battery
Note: Do not install the battery while the Bark Control Collar is on your dog.
1. Align the triangles on the battery
and the Bark Control Collar (A).
2. Use a coin to turn the battery
clockwise until the triangle lines
up with the “On” position if you
are putting it on the dog or the
“Off” position if it is not being put
on the dog right away (B).
3. To remove the battery, turn the
battery counter-clockwise using a
coin (C, D). DO NOT attempt to
cut into or pry open the battery.
Be sure to discard the used
battery properly.
AB
DC
This Bark Control Collar utilizes a replaceable PetSafe
®
battery
(RFA-188). This unique battery is designed to make battery replacement
easier and increase water protection.
To Next Page
Loading...
