• Most dogs will feel uncomfortable when wearing collar for the rst time. Don’t
use any commands until your dog has gotten used to the collar which will normal-
ly take several days.
• Eliminate one unwanted action or teach one obedience command at a time. If
you move to quickly with training, your dog may become confused.
• Be consistent in your training. Give your dog the same stimulation for each
unwanted action. We suggest you to use Vibration Stimulation before starting the
Static Shock Stimulation. If you follow this training method, your dog will learn
that Static Shock Stimulation might come aer Vibration. Hence, the Vibration
Stimulation alone can eectively cure unwanted behavior of your dog.
• Do not over-correct. Use as few stimulation as possible to train your dog.
• Following a predened scenario in all Training Sessions can dramatically improve
your chances of success.
• Should your dog react to the training by hiding or reacting fearfully, redirect his
attention to a simple command such as “Speak” or “Sit” to calm him down. Use
treats to help your dog understand which commands have been done correctly.
TROUBLESHOOTING
My PetSpy Premium Dog Training Collar is not working?
•Make sure that both the Remote Transmitter and Receiver Collar are fully
charged.
•Please follow the steps from
Synchronizing Remote Transmitter with Receiver
Collar
paragraph to make sure that transmitter is in sync with collar.
CAUTION: While the Receiver Collar is waterproof, the Remote Transmitter is
not and must be kept in a dry place! Water can irreversibly damage the Remote
Transmitter!
REGULAR MAINTENANCE AND STORAGE
•When not used, PetSpy Dog Training System must be kept in a dry place just like
any other electronic device.
•To prevent batteries from damage, charge both the Transmitter and Receiver
regularly even when it’s not used. Make sure you do not charge it for longer than 4
hours.
•Clean the receiver and contact points weekly.
•Check your dog’s neck for irritation weekly.
To Next Page
Loading...
