TESTING PETSPY DOG TRAINING SYSTEM
Static Shock Test:
•Take the included Test Light Kit and put its metal wire
on the Receiver Collar’s Contact Points.
•Press the Static Shock Button on the Remote Transmitter.
•e Test Light will light up indicating that Shock is
working.
•e higher the Shock level is the brighter it should be.
Vibration Test:
•Press the Vibration Button on the Remote Transmitter.
•e Receiver Collar will vibrate indicating that Vibration Stimulation is working.
•Try to adjust the level of vibration and see how the intensity is changing.
Receiver Tone/Beep Test:
•Press the Receiver Tone Button on the Remote Transmitter.
•e Receiver Collar will beep indicating that Receiver Tone is working.
COLLAR FITTING:
CAUTION: proper tting and placement of PetSpy Dog Training Collar is import-
ant for eective training. e collar must t your dog securely, but loose enough to
allow one nger space between the collar and your dog’s neck. e Contact Points
must have direct contact with your pet’s skin on the underside of dog’s neck.
Putting the Collar On:
1. Have your dog standing comfortably.
2. Center the Contact Points beneath the dog’s neck and touching the skin.
3. e Collar should t securely, yet loose enough to allow one nger space be-
tween the collar and dog’s neck.
4. Allow your dog to wear the collar for several minutes and check the tment
again when your dog becomes more comfortable wearing the collar.
FIND THE BEST STIMULATION LEVEL FOR YOUR DOG
CAUTION: Start with Vibration mode and use Static Shock only as a last resort.
PetSpy e-collar is a powerful tool for encouraging desired dog’s behavior. But
rst, you must identify an e-collar intensity setting for your dog - it has to be high
enough to be noticed, but not so high as to be disruptive. Your dog must learn to
act in response to the e-collar stimulation and understand that he can control it by
his actions.
To Next Page
Loading...
