PREPARING REMOTE TRANSMITTER FOR YOUR FIRST USE:
Make sure that Remote Transmitter is charged before proceeding to the training:
1. e charging port is located at the bottom of remote. Carefully insert the
charging cable into the charging port.
2. e Battery Charge Indicator will start ashing. It takes about 3-4 hours to get a
full charge.
3. e remote transmitter is not waterproofed - keep it in a dry place!
REMOTE TRANSMITTER OPERATION
1. e remote always stays in the Stand-by Mode. Simply press any button to wake
it up.
2. If you have 2 or 3 collars, you can select which collar is being controlled (1, 2, 3)
by pressing the Channel Switch Button.
3. Press the Vibration Button to deliver Vibration Stimulation to your dog.
4. Press the Static Shock Button to deliver Static Shock to your dog.
5. Press the Tone/Beep Button to deliver beeping tone to your dog.
6. You are welcome to attach a lanyard for your convenience.
To Next Page
Loading...
