Setting up
32
9.08 Setting up the bobbin thread counter
With the machine in its basic position, select the input mode.
With the corresponding +/- key select parameter "004".
If required, enter the access code, see Chapter 11.04.01 Entering the access code.
●
●
●
With the corresponding +/- key switch on the bobbin thread counter.
With the corresponding +/- key enter the number of workpieces to be sewn.
Conclude the input by pressing the TE key. (Machine changes to the sewing mode).
●
●
●
No VAL
004 ON 800
9.09 Resetting the piece counter
In the sewing mode (basic position of the machine) the piece counter or the bobbin thread
counter can be displayed by pressing the menu key. (When the bobbin thread counter is
switched off, the piece counter is displayed - Selection under parameter 004) .
20 SET 0
The piece counter counts from 0 onwards and differs from the bobbin thread counter in the
display through the upwards pointing arrow.
Reset the piece counter with the corresponding +/- keys. ●
To Next Page
Loading...
