Sewing
35
10 Sewing
The machine must be installed, connected and set up as described in Chapter 8
Installation and Commissioning.
The machine must not be operated without the safety devices 1 to 5, see Chap-
ter 1.06 Danger warnings! Danger of injury!
Fig. 9 - 02
1
2
5
4
3
10.01 Operating cycle
Carry out all steps in accordance with Chapter 9 Setting up.
Place the material properly under the work clamp.
Lower the work clamp and start the sewing cycle, see Chapter 7.02 Pedal.
10.02 Sewing in the "Direct program selection" mode
In this function, a seam pattern is selected. After selection, the speed and size can be alte-
red, see Chapter 9.06.01 Selecting and changing the seam pattern.
10.03 Sewing in the "Program stations" mode
Program stations can be selected, which have been reserved beforehand with a seam pat-
tern with relevant speed and size factors, see Chapter 11.01 Reserving program stations.
●
●
●
To Next Page
Loading...
Need help?
General
