Sewing
36
10.04 Sewing in the "Sequences mode".
Sequences, which have been created beforehand, can be called up with the function keys
C1 to C3 (see Chap. 11.02.01 Entering sequences)
10.04.01 Interrupting a sequence
If an interruption occurs during a sequence cycle (e.g. broken thread), it is possible to
continue at the same sequence point after the error has been eliminated.
The procedure is as follows:
Correct the error.
Acknowledge the correction of the error by pressing the corresponding +/- key or by
switching the machine off and on.
The diode in the memory card slot (see arrow) turns yellow again
●
●
●
10.05 Error messages
When an error occurs, the text "ERROR" appears on the display together with an error
code and short instructions. In addition the diode in the memory card slot lights up red
(see arrow). An explanation of the error codes can be found in the Chapter 11.07 Error
messages on the display.
The activated sequence point flashes.
Select the sequence A, B or C by pressing the left +/- key.
Press the corresponding +/- key to move to the sequence point to be repeated.
Conclude input by pressing the TE key.
●
●
●
●
A 3 - 3 - 3 - 3 - 3 - 3 - 8
8 - 8 - 8 - 4 - 4
ERROR: 003
RESET
To Next Page
Loading...
Need help?
General
