Input
60
Group
Gruppe
Parameter
Parameter
Description
Bedeutung
Setting
range
Set value
600 606 Thread trimming sequence
The sequence for a complete thread
trimming cycle is started with the +/-
key (+) below CUT and below THR.
607 Cold start (RESET)
With this function the control unit
carries out a cold start (RESET) with
which the data is reset. After this func-
tion has been selected, the machi-
ne must be switched off and then on
again.
608 Setting zero points
With this function and the adjustment
gauge, the zero points for the X/Y-drive
unit can be set. (stepping motor cor-
rection values for the reference points
REFX, REFY). The access code is
required for this adjustment.
609 Setting the clamp centre X
This function is used to set the cen-
tre of the clamp in X-direction. When
entering the function, the machine
moves to the current clamp centre,
after which it is possible to move to
the right or left edge of the clamp,
depending on the set limits (param.
"023"). A correction can be made with
the plus/minus keys. The relocation va-
lue is displayed.
610 Setting the clamp centre Y
This function is used to help set the
centre of the clamp in Y-direction. Af-
ter entering this function, the machine
moves to the current clamp centre,
after pressing a key to the front or the
rear limit (param. "024"). The clamp
must be shifted manually.
To Next Page
Loading...
Need help?
General
