Input
62
ERROR: 5 Processor error ILLEGAL_WORD_OPERAND
ERROR: 6 Processor error ILLEGAL_INSTRUCTION
ERROR: 7 Processor error ILLEGAL_BUS_ACCESS
ERROR: 8 Processor error NMI
ERROR: 10 OTE (Sewing head recognition unit) not attached
ERROR: 11 OTE not programmed (new)
ERROR: 12 OTE check sum error
ERROR: 13 OTE header invalid
ERROR: 14 OTE user data invalid
ERROR: 30(#) (OTE error see cap. 11.10)
ERROR: 31(#) (Error Sewing motor see cap. 11.09)
ERROR: 50 Incorrect control panel
ERROR: 51 Incorrect machine class in OTE
ERROR: 52 Incorrect software for main drive
ERROR: 101 Mains voltage
ERROR: 102 Power supply overload
ERROR: 103 24 V too low
ERROR: 201(#) (Error Sewing motor see cap. 11.09)
ERROR: 202 Pattern too large
ERROR: 203 Overload data transfer sewing motor
ERROR: 204 Tacting function locked
ERROR: 205 Run function locked
ERROR: 206 No NIS
ERROR: 207 Not end of ramp
ERROR: 208 Zero point not found
ERROR: 209 Sewing function locked
ERROR: 210 Bobbin thread fault
ERROR: 211 Stitch too large
ERROR: 301 Raise clamp not completed
ERROR: 302 Lower clamp not completed
ERROR: 303 Raise clamp locked (needle position)
ERROR: 304 Lower clamp locked (needle position)
ERROR: 305 Thread wiper on locked (needle position)
ERROR: 401 Error sewing motor
ERROR: 402 Overload data transfer sewing motor
ERROR: 403 Program station not programmed
ERROR: 404 Program locked
ERROR: 405 Program does not exist
ERROR: 406 No NIS
ERROR: 407 Zero points invalid
ERROR: 408 Machine not in basic position
To Next Page
Loading...
Need help?
General
